MX1508 2-channel DC motor controller

5,00 

3 na zalogi

Kategorija:

Opis

  • Dual H-bridge motor driver, can drive two DC motors or a 4-wire two-phase stepper motor.
  • The module supply voltage 2V-10V.
  • Signal input voltage 1.8-7V.
  • Single Operating current 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA).
  • Built-in common conduction circuit, when the input pin is left floating, the motor does not malfunction.
  • Built-in thermal protection circuit with hysteresis effects (TSD), without worrying about motor stall.
  • Product Size: 24.7 * 21 * 5mm (length, width, height), ultra-small size.
  • The mounting hole diameter: 2 mm

Mnenja

Zaenkrat še ni mnenj.

Samo prijavljeni uporabniki, ki so kupili ta izdelek, lahko napišejo mnenje.